Reply to thread

Message

<blockquote data-quote="Freelander" data-source="post: 4886198" data-attributes="member: 576814">I need a design made and also a cut sheet but I could figure that out usually from the sketchup.The box design is for a 15&quot; FiQ sub. It will be ran off a MMATS D300HC. I&#039;m looking for&nbsp; between 3.5-4 cubes after sub and port displacement. I&#039;ve already ordered two 4&quot; precision ports and they should be here this week. <a href="http://www.partsexpress.com/pe/showdetl.cfm?&amp;amp;Partnumber=268-352" target="_blank">These are the port kits I bought</a>. If they need to be cut down please let me know how to do so because I&#039;ve always used slot ports. If you can design a box that the ports don&#039;t need to be cut at all even better.I&#039;d like the tunning to be 33hz. I can do 39&quot; wide, 25&quot; deep and I would like to keep it under 25&quot; tall if I can but can be taller if needed. Its going in a small suv so whatever port config you think will sound best.Wanting to get started on the box build asap. If you charge for designs PM me a price and show me some of your past work and we&#039;ll take it from there.</blockquote>

[QUOTE="Freelander, post: 4886198, member: 576814"] I need a design made and also a cut sheet but I could figure that out usually from the sketchup. The box design is for a 15" FiQ sub. It will be ran off a MMATS D300HC. I'm looking for between 3.5-4 cubes after sub and port displacement. I've already ordered two 4" precision ports and they should be here this week. [URL="http://www.partsexpress.com/pe/showdetl.cfm?&Partnumber=268-352"]These are the port kits I bought[/URL]. If they need to be cut down please let me know how to do so because I've always used slot ports. If you can design a box that the ports don't need to be cut at all even better. I'd like the tunning to be 33hz. I can do 39" wide, 25" deep and I would like to keep it under 25" tall if I can but can be taller if needed. Its going in a small suv so whatever port config you think will sound best. Wanting to get started on the box build asap. If you charge for designs PM me a price and show me some of your past work and we'll take it from there. [/QUOTE]

Verification