Reply to thread

Message

<blockquote data-quote="SlickCMRick" data-source="post: 2224181" data-attributes="member: 571020">Right now I have crystal mobile sound SSX615&#039;s for my front stage, and I kept the tweeter on its bridge with the speaker.&nbsp; I also have lanzar tweeters mounted on my door.&nbsp; Each speaker gets 75w from my Eclipse EA4000.&nbsp; If I bridged the amp it would be 150 x 2.&nbsp; I&#039;m looking to buy some new Rainbow SLC 265&#039;s.&nbsp; I can&#039;t decide how i should do the install though.I can either take out my crappy rear pioneers and put my crystals in there.&nbsp; I can run them off my HU and run my rainbows with 150w going to each side.&nbsp; OR I can run the crystals off an alpine 40x4 amp and just keep 2 channels disconnected, so i will have 2 4 ch. ampsOR I can put my crystals in the back, rainbows in the front, ran at 75 rmsx4.&nbsp; Not sure if 75 is enough though, I want them to be loud with minimal to no distortionI also plan on deadening the doors when i get the cashWhat is the best way to do it?</blockquote>

[QUOTE="SlickCMRick, post: 2224181, member: 571020"] Right now I have crystal mobile sound SSX615's for my front stage, and I kept the tweeter on its bridge with the speaker. I also have lanzar tweeters mounted on my door. Each speaker gets 75w from my Eclipse EA4000. If I bridged the amp it would be 150 x 2. I'm looking to buy some new Rainbow SLC 265's. I can't decide how i should do the install though. I can either take out my crappy rear pioneers and put my crystals in there. I can run them off my HU and run my rainbows with 150w going to each side. OR I can run the crystals off an alpine 40x4 amp and just keep 2 channels disconnected, so i will have 2 4 ch. amps OR I can put my crystals in the back, rainbows in the front, ran at 75 rmsx4. Not sure if 75 is enough though, I want them to be loud with minimal to no distortion I also plan on deadening the doors when i get the cash What is the best way to do it? [/QUOTE]

Verification