Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
Amplifiers
setting components' crossover
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="noob with an RS" data-source="post: 701011" data-attributes="member: 558925"><p>hey i have a set of infinity perfect 6.1 components and i am using a Hifonics nx600 to power it (150 watts x2). should i set the crossover on my alpine to OFF and use the crossover on the hifonics? i'm thinking about doing this because the lowest crossover point the deck can do is 80 hZ.. and my perfects frequency response starts at 75 hZ.. so basically i was thinking turn the x-over on the HU off and use the amp to fine-tune it. or would it just be a lot better to have my great Alpine 7995 to crossover the highs at 80 hZ?? if i use the head unit to do the crossing over then i <strong>should</strong> and <em>could</em> set the crossover to FULL right? any feedback will be greatly appreciated. thanks.</p></blockquote><p></p>
[QUOTE="noob with an RS, post: 701011, member: 558925"] hey i have a set of infinity perfect 6.1 components and i am using a Hifonics nx600 to power it (150 watts x2). should i set the crossover on my alpine to OFF and use the crossover on the hifonics? i'm thinking about doing this because the lowest crossover point the deck can do is 80 hZ.. and my perfects frequency response starts at 75 hZ.. so basically i was thinking turn the x-over on the HU off and use the amp to fine-tune it. or would it just be a lot better to have my great Alpine 7995 to crossover the highs at 80 hZ?? if i use the head unit to do the crossing over then i [B]should[/B] and [I]could[/I] set the crossover to FULL right? any feedback will be greatly appreciated. thanks. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Amplifiers
setting components' crossover
Top
Menu
What's new
Forum list
