Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
SDC2.5 parallel at 2 ohm
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="fraser11" data-source="post: 6949824" data-attributes="member: 620790"><p><a href="http://a248.e.akamai.net/pix.crutchfield.com/ca/learningcenter/car/subwoofer_wiring/1DVC_4-ohm_mono.jpg" target="_blank">http://a248.e.akamai.net/pix.crutchfield.com/ca/learningcenter/car/subwoofer_wiring/1DVC_4-ohm_mono.jpg</a></p><p></p><p>The only issue I have with this is audioque uses direct connect wires to the subwoofer. Because of this, I cannot run the jumper wire between the two + a=nd - terminals(since they dont have any). To correctly run a parallel, would I run both + wires to the + terminal cup on the box and vice versa for the -? Then run it to the amp?</p><p></p><p>DVC 4ohm</p><p></p><p>If this is not the correct way to run it please explain where I went wrong.</p><p></p><p>Thanks</p></blockquote><p></p>
[QUOTE="fraser11, post: 6949824, member: 620790"] [URL="http://a248.e.akamai.net/pix.crutchfield.com/ca/learningcenter/car/subwoofer_wiring/1DVC_4-ohm_mono.jpg"]http://a248.e.akamai.net/pix.crutchfield.com/ca/learningcenter/car/subwoofer_wiring/1DVC_4-ohm_mono.jpg[/URL] The only issue I have with this is audioque uses direct connect wires to the subwoofer. Because of this, I cannot run the jumper wire between the two + a=nd - terminals(since they dont have any). To correctly run a parallel, would I run both + wires to the + terminal cup on the box and vice versa for the -? Then run it to the amp? DVC 4ohm If this is not the correct way to run it please explain where I went wrong. Thanks [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
SDC2.5 parallel at 2 ohm
Top
Menu
What's new
Forum list
