Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
saved presets
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="gst" data-source="post: 8537479" data-attributes="member: 671780"><p>I have a Jensen 1130 radio mounted in a Kubota RTV. This radio uses a memory capacitor to save preset channels, there is only a power wire, which goes through the switch, a ground and speaker wires. About once every few days the radio looses the presets, this is actually the third radio I have tried, all the same model (the Kubota dealer has replaced them). All three radios have been on ample time to charge the capacitor, which is what the folks at Jensen told me to do. Could there be an electrical issue with the Kubota? Radio plays/works fine but is a pain to continually program stations back in. With only 1 hot wire that is hooked to the factory wiring harness, wiring is not an issue, the radio goes off when the key is turned off. If there is anybody who could help me I would be greatly appreciative. Thanks!</p></blockquote><p></p>
[QUOTE="gst, post: 8537479, member: 671780"] I have a Jensen 1130 radio mounted in a Kubota RTV. This radio uses a memory capacitor to save preset channels, there is only a power wire, which goes through the switch, a ground and speaker wires. About once every few days the radio looses the presets, this is actually the third radio I have tried, all the same model (the Kubota dealer has replaced them). All three radios have been on ample time to charge the capacitor, which is what the folks at Jensen told me to do. Could there be an electrical issue with the Kubota? Radio plays/works fine but is a pain to continually program stations back in. With only 1 hot wire that is hooked to the factory wiring harness, wiring is not an issue, the radio goes off when the key is turned off. If there is anybody who could help me I would be greatly appreciative. Thanks! [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
saved presets
Top
Menu
Home
Refresh