Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
General Car Audio
Rookie here..need some help
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="boomchee" data-source="post: 6942222" data-attributes="member: 624836"><p>Ok I had to go recheck some things and get some exact measurements. The enclosure is:</p><p></p><p>18in 11/16 w</p><p></p><p>13in 3/4 ht</p><p></p><p>12in d top</p><p></p><p>16in 1/2 bottom</p><p></p><p>2 1/2 in port</p><p></p><p>btw...I said 8ga wire was being used before when it's actually 6 ga. I believe it was mentioned that I should be using 4 ga. After having this amp for a week I'm starting to think about upgrading the sub to a p3d212 (500 rms/1000pk). The p2d212 i'm using now is only 250rms/500pk. Would the amp (rf r500-1) be able to effectively push the p3?</p></blockquote><p></p>
[QUOTE="boomchee, post: 6942222, member: 624836"] Ok I had to go recheck some things and get some exact measurements. The enclosure is: 18in 11/16 w 13in 3/4 ht 12in d top 16in 1/2 bottom 2 1/2 in port btw...I said 8ga wire was being used before when it's actually 6 ga. I believe it was mentioned that I should be using 4 ga. After having this amp for a week I'm starting to think about upgrading the sub to a p3d212 (500 rms/1000pk). The p2d212 i'm using now is only 250rms/500pk. Would the amp (rf r500-1) be able to effectively push the p3? [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
General Car Audio
Rookie here..need some help
Top
Menu
What's new
Forum list
