Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Discussion
Car Audio Build Logs
Rockville W12K6D4 V2 K6 Series 12" Dual 4-Ohm Car Subwoofer
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="DStringham435" data-source="post: 8753494" data-attributes="member: 683470"><p>Just made a discovery today I need help with. The subs are hooked up within a bandpass box. I have the positive and negative lead from one side then connects to the other side followed by a single wire for both sides that lead to the speaker box terminals. I have used 5 different amps with these subs and all of them would go into protect mode after turning the volume up. The amps used do not do this when connected to other speakers. Help?</p><p></p><p>[ATTACH=full]30556[/ATTACH]</p></blockquote><p></p>
[QUOTE="DStringham435, post: 8753494, member: 683470"] Just made a discovery today I need help with. The subs are hooked up within a bandpass box. I have the positive and negative lead from one side then connects to the other side followed by a single wire for both sides that lead to the speaker box terminals. I have used 5 different amps with these subs and all of them would go into protect mode after turning the volume up. The amps used do not do this when connected to other speakers. Help? [ATTACH type="full" alt="20210706_111714.jpg"]30556[/ATTACH] [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Car Audio Build Logs
Rockville W12K6D4 V2 K6 Series 12" Dual 4-Ohm Car Subwoofer
Top
Menu
Home
Refresh