Reply to thread

Message: <blockquote data-quote="Surfed80" data-source="post: 655506" data-attributes="member: 558068"><p>I am running 2 12" Premier 2000SPL wired at 2ohm each so its a 1ohm load on the amp.  The 1001BD is stable at 1ohm and will put out about 1300 at that well my question is what should I have the LPF setting at?  I have each 12 in a sealed box and with the gain at about a tad under half at half the subs max out.  Also if I raise the low pass up like at about 80-85 they tend to max out like I could have the gain at about half and lower my low pass and they wont max out.  What do you think I should have my lpf at?  70?  and then raise the gain until the subs are maxing out and then back off?  I dont understand each Premier can handle 750rms but 1300 to both of them with the gain under half is maxing them out?  Are these 04 RF Power amps that good?  Thanks</p></blockquote><p></p>

Top