Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
Speakers
RF Power 1000 and RE Speakers
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="JoeSmith502" data-source="post: 4457329" data-attributes="member: 569911"><p>OK, here is the situation. I have a set of RE XXX comps that are 2 ohm and a RF Power 1000 amp. The RF amp is rated 100 x 4 @ 2 and the sub channel is either 300 x1 @ 4, 600 x 1 @ 2 or 800 x 1 @ 1. I already have two XXX 12's in the trunk so with the sub channel on the RF I was going to run some 8" in the cabin. I know you are supposed to keep all your subs the same but RE doesn't make a XXX 8" but I did find some RE Series 8" that are rated 175rms. Would it be ok to run these along with my other subs? They are D4 so I could either run 2 at 4ohm or 3 at 2.6ohm. I will also be using the RE 6x9 in the rear deck wired together to get them to 2 ohm and I am going to make a center channel too, so will adding the 8"s just be overkill? Thanks for your help!</p></blockquote><p></p>
[QUOTE="JoeSmith502, post: 4457329, member: 569911"] OK, here is the situation. I have a set of RE XXX comps that are 2 ohm and a RF Power 1000 amp. The RF amp is rated 100 x 4 @ 2 and the sub channel is either 300 x1 @ 4, 600 x 1 @ 2 or 800 x 1 @ 1. I already have two XXX 12's in the trunk so with the sub channel on the RF I was going to run some 8" in the cabin. I know you are supposed to keep all your subs the same but RE doesn't make a XXX 8" but I did find some RE Series 8" that are rated 175rms. Would it be ok to run these along with my other subs? They are D4 so I could either run 2 at 4ohm or 3 at 2.6ohm. I will also be using the RE 6x9 in the rear deck wired together to get them to 2 ohm and I am going to make a center channel too, so will adding the 8"s just be overkill? Thanks for your help! [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Speakers
RF Power 1000 and RE Speakers
Top
Menu
What's new
Forum list