Reply to thread

Message: <blockquote data-quote="Sizzlechest" data-source="post: 8322508" data-attributes="member: 661234">Thanks for the reply, I'll go with this approach.With my DMM it is reading 19.5 when I test the lower outside posts on the pot; when I use the middle post in the test with one on the outside it does go up and down accordingly depending on the pot position. Can I assume this is a 20k pot or is it actually a 19.5? And since there are 6 posts on this pot, is one for the left channel (top set), one for right (bottom set)?I was going to follow the below site for re-wiring once I figure out what wires do what in the telephone jack. Are pots consistent with what each pin does? I couldn't find a telephone plug so I'm going to pick one up. For now I was testing directly on the circuit board.<a href="http://www.bcae1.com/potentio.htm" target="_blank">Potentiometer</a></blockquote>

Top