Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
Amplifiers
Refurbished specs different?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="solidcrowd" data-source="post: 2217306" data-attributes="member: 565671"><p>I was looking at the refurbished kicker zx1000.1's on ebay and i found these specs to be different from another</p><p></p><p>First:</p><p></p><p>Amplifier Type 1 Channel</p><p></p><p>RMS Power: 500W x 1 @ 4 ohms THD at 4-Ohm RMS Power:</p><p></p><p>RMS Power: 1,000W x 1 @ 2 ohms</p><p></p><p>Speaker Level Inputs: Yes</p><p></p><p>Preamp Outputs: Yes</p><p></p><p>Built-In Crossovers: LP</p><p></p><p>Bass Boost: 0 - 18 dB</p><p></p><p>Frequency Response: 25-200Hz</p><p></p><p>Signal to Noise Ratio: 60 dB</p><p></p><p>Fuse Rating: n/a</p><p></p><p>Advanced chassis with extruded aluminum heatsink</p><p></p><p>Efficient class D circuitry</p><p></p><p>Top-mounted controls</p><p></p><p>KickBass 0-18 dB variable bass boost at 40 Hz</p><p></p><p>Variable 50-200 Hz low-pass crossover with 24 dB/octave slope</p><p></p><p>Defeatable 25 Hz subsonic filter</p><p></p><p>High level or low level inputs (125mV-10V)</p><p></p><p>PreAmp Signal Transfer (PAST) RCA outputs</p><p></p><p>Delayed turn-off logic circuit</p><p></p><p>Soft start turn-on circuit for reduced startup load</p><p></p><p>Short circuit, Over-voltage, Reverse polarity, Thermal overload (SORT) protection</p><p></p><p>Included remote KickBass control</p><p></p><p>Fully CEA-2006 compliant specifications for real-world power</p><p></p><p>Second:</p><p></p><p>Specifications :</p><p></p><p>Class D Mono 1 channel Design</p><p></p><p>1000W RMS X 1 @ 2 ohm</p><p></p><p>500W RMS x 1 @ 4 ohms</p><p></p><p>Gain and crossover frequency control</p><p></p><p>Top Mounted controls make it easy to adjust this amp at any time</p><p></p><p>Protection light indicator</p><p></p><p>Mosfet Powered</p><p></p><p>Soft Start turn-on</p><p></p><p>Protection Circuit</p><p></p><p>S/N Ratio: &gt;95 dB</p><p></p><p>Built in crossovers: 24 dB per octave low-pass crossover (50 - 200 HZ)</p><p></p><p>Bass Boost (0-18 dB)</p><p></p><p>12 dB defeat able sub sonic filter</p><p></p><p>Free remote bass boost</p><p></p><p>Frequency response 20-20,000 Hz</p><p></p><p>Equalizer for bass w/ variable gain that goes up to 18dB</p><p></p><p>4 AWG Power and Ground (recommended)</p><p></p><p>Dimensions: 9-5/8" x 2-1/8" x 16-3/4"</p><p></p><p>Which one is better if they are actually different??</p></blockquote><p></p>
[QUOTE="solidcrowd, post: 2217306, member: 565671"] I was looking at the refurbished kicker zx1000.1's on ebay and i found these specs to be different from another First: Amplifier Type 1 Channel RMS Power: 500W x 1 @ 4 ohms THD at 4-Ohm RMS Power: RMS Power: 1,000W x 1 @ 2 ohms Speaker Level Inputs: Yes Preamp Outputs: Yes Built-In Crossovers: LP Bass Boost: 0 - 18 dB Frequency Response: 25-200Hz Signal to Noise Ratio: 60 dB Fuse Rating: n/a Advanced chassis with extruded aluminum heatsink Efficient class D circuitry Top-mounted controls KickBass 0-18 dB variable bass boost at 40 Hz Variable 50-200 Hz low-pass crossover with 24 dB/octave slope Defeatable 25 Hz subsonic filter High level or low level inputs (125mV-10V) PreAmp Signal Transfer (PAST) RCA outputs Delayed turn-off logic circuit Soft start turn-on circuit for reduced startup load Short circuit, Over-voltage, Reverse polarity, Thermal overload (SORT) protection Included remote KickBass control Fully CEA-2006 compliant specifications for real-world power Second: Specifications : Class D Mono 1 channel Design 1000W RMS X 1 @ 2 ohm 500W RMS x 1 @ 4 ohms Gain and crossover frequency control Top Mounted controls make it easy to adjust this amp at any time Protection light indicator Mosfet Powered Soft Start turn-on Protection Circuit S/N Ratio: >95 dB Built in crossovers: 24 dB per octave low-pass crossover (50 - 200 HZ) Bass Boost (0-18 dB) 12 dB defeat able sub sonic filter Free remote bass boost Frequency response 20-20,000 Hz Equalizer for bass w/ variable gain that goes up to 18dB 4 AWG Power and Ground (recommended) Dimensions: 9-5/8" x 2-1/8" x 16-3/4" Which one is better if they are actually different?? [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Amplifiers
Refurbished specs different?
Top
Menu
What's new
Forum list
