Reply to thread

Message: <blockquote data-quote="helmsnd" data-source="post: 5135347" data-attributes="member: 603046"><p>I just ordered an RE Audio RE10 to replace my MTX Thunder 6000 until I get the money to replace my amp.  I have never wired up a dual voice coil sub so I am wondering what the best way to do that is.  My amp is an MTX thunder 421d.  Should I hook each voice coil up separately on the amp or bridge them and run it at 2 ohms?  The sub is rated at 175w RMS which I assume is per voice coil and the amp puts out 150w RMS per channel at 4ohms.  If I bridged it at 2 ohms the amp puts out 300w RMS.  I just want to make sure I don't hurt anything.  I know people run way more than rated on the other RE subs but haven't heard much about the RE series.</p></blockquote><p></p>

Top