Reply to thread

Message: <blockquote data-quote="Daniel" data-source="post: 67031" data-attributes="member: 542295">I believe it was you who had the ALUMX10, well im looking into buying the ALUMX12 and i was wondering what OHM load would be the easiest to work with; 12, 6, or 3 ohm vc's.  I am going to push it with a JBL 600.1 ( i read your review on the board saying they dont take higher than RMS too good so im not gonna push it ).  SO im wondering is there any way i can get the ALUMX12 to get the 600W from the jbl without getting to low on the amp load?  I am only looking into getting one of them so how would i wire it?thanks</blockquote>

Top