Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
Rainbow Install on paper... Looking for a second opinion
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Incudie" data-source="post: 3685734" data-attributes="member: 582795"><p>Ok so I have everything layed out on a table plugged into the computer and car... about to wire the speakers and looking on configurations.</p><p></p><p>These are the Kick versions of the CMX 265s. I am reading the manual and it looks like I need to set the Front and Rear to Highpass.</p><p></p><p>So based on the above diagram, could someone agree that I should have both the rear and front bridged channels set in high pass mode?</p><p></p><p>Or should I leave them in "Broadband Mode" since I am using the X-overs that are wired inline between the mids and tweeters?</p><p></p><p>Since bridged, it would be 2x270... Thats fine right? I just need to set my gain very low and calibrate it with an oscilloscope?</p><p></p><p>Thanks!</p><p></p><p>--Incudie</p></blockquote><p></p>
[QUOTE="Incudie, post: 3685734, member: 582795"] Ok so I have everything layed out on a table plugged into the computer and car... about to wire the speakers and looking on configurations. These are the Kick versions of the CMX 265s. I am reading the manual and it looks like I need to set the Front and Rear to Highpass. So based on the above diagram, could someone agree that I should have both the rear and front bridged channels set in high pass mode? Or should I leave them in "Broadband Mode" since I am using the X-overs that are wired inline between the mids and tweeters? Since bridged, it would be 2x270... Thats fine right? I just need to set my gain very low and calibrate it with an oscilloscope? Thanks! --Incudie [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
Rainbow Install on paper... Looking for a second opinion
Top
Menu
What's new
Forum list
