Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
questions about wiring to front speakers
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Ven0m" data-source="post: 8670873" data-attributes="member: 676151"><p>I have a 09 Saturn Aura XR (l4) and am wanting to take use of the other 2 channels on my amp. I have already amlified the rear deck speakers however i really dont want to have to take the door panels off to run new wire. So my question is where would you splice into factory wiring at? I googled a wiring diagram and it said that the front left speaker wires are gray and tan. So I took the trim off on driver side of vehicle and saw a gray wire, I cut this gray wire hoping that it would make the door speaker stop playing however it was not the correct wire. I really dont want to take the dash out again or take door panels off as that is a pain in the ass. any suggestions?</p></blockquote><p></p>
[QUOTE="Ven0m, post: 8670873, member: 676151"] I have a 09 Saturn Aura XR (l4) and am wanting to take use of the other 2 channels on my amp. I have already amlified the rear deck speakers however i really dont want to have to take the door panels off to run new wire. So my question is where would you splice into factory wiring at? I googled a wiring diagram and it said that the front left speaker wires are gray and tan. So I took the trim off on driver side of vehicle and saw a gray wire, I cut this gray wire hoping that it would make the door speaker stop playing however it was not the correct wire. I really dont want to take the dash out again or take door panels off as that is a pain in the ass. any suggestions? [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
questions about wiring to front speakers
Top
Menu
Home
Refresh