Reply to thread

Message: <blockquote data-quote="microhaxo" data-source="post: 5388201" data-attributes="member: 570733">Shouldn't i worry about the voltage though?  I don't want to end up sending a clipped signal to the sub.Also this would mean that i would have to go to volume level 24 again. at volume 24 i am able to not use ANY low and sub level is set at about 1 out of 5, but it seems that every notch on the sub level is about 1.7v increase on the amp. So i think the lowest volume i could go with 0 low is 22.Could you explain this "boost" around 60hz, am i unable to see any voltage increase from this?When i use 0 low and obtain 45v on the amp the output is much lower than when i obtain 45v with low setting of 6.</blockquote>

Top