Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
Question about power distribution and wiring three subs to single monoblock
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="strykerlee" data-source="post: 8523213" data-attributes="member: 670998"><p>Hello everyone, I have a question about monoblock amps.</p><p></p><p>I have a rockford r1200.1 (1200w rms @ 1 ohm) and intent to run a rockford p312d4 (600w rms) and 2 jl 12w3v2-d2 ( each 300w rms)</p><p></p><p>I plan to wire the p3 in parallel @ 2 ohms to one side of the amp</p><p></p><p>and each jl wired in series to 4 ohm, then both in parallel to the other hookup on the amp @ 2 ohm</p><p></p><p>making a final impedence of 1 ohm on the amp.</p><p></p><p>So the question is, would the power be split 600w rms to each lead (600 to the rf, and 300 to each jl), or would it power each sub with 400w rms?</p></blockquote><p></p>
[QUOTE="strykerlee, post: 8523213, member: 670998"] Hello everyone, I have a question about monoblock amps. I have a rockford r1200.1 (1200w rms @ 1 ohm) and intent to run a rockford p312d4 (600w rms) and 2 jl 12w3v2-d2 ( each 300w rms) I plan to wire the p3 in parallel @ 2 ohms to one side of the amp and each jl wired in series to 4 ohm, then both in parallel to the other hookup on the amp @ 2 ohm making a final impedence of 1 ohm on the amp. So the question is, would the power be split 600w rms to each lead (600 to the rf, and 300 to each jl), or would it power each sub with 400w rms? [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
Question about power distribution and wiring three subs to single monoblock
Top
Menu
Home
Refresh