Reply to thread

Message

<blockquote data-quote="yacob.naif" data-source="post: 1991342" data-attributes="member: 565696">Hey gang, spent the night assembling a 10cf birch box for my L7&#039;s, but i have a question/problem i need help with in preparation for tomorrow.I mitred the corners of my box, so the 90 degree angle clamps i was intending to use for assmembling the box were useless, so i had to resort to 16 odd c-clamps on the tops and bottoms of each corner, clamping 2x2&#039;s.It didn&#039;t occur to me until much too late that those 2x2&#039;s may incidently become a fixture in my box //content.invisioncic.com/y282845/emoticons/crap.gif.7f4dd41e3e9b23fbd170a1ee6f65cecc.gif hahaha, good thinking, i know.I was wondering if there&#039;d be a way for me to chisel the 2x2&#039;s out of the corners?I&#039;d leave them be, but they&#039;re not flush with the box, i don&#039;t think i&#039;ll be able to get the top and bottom of the box on with the 2x2&#039;s there.I don&#039;t know if it&#039;s possible or not, i just don&#039;t have much experience (any) with gorilla glue.Is there any glimmor of hope in my future?&nbsp; Or am i gonna be spending a few hours DRILLING 2x2&#039;s out of my beautiful baby //content.invisioncic.com/y282845/emoticons/crying.gif.ec0ebefe590df0251476573bc49e46d8.gifso frustrating after 9 hours of work.... i&#039;ve never even mitred before, and i didn&#039;t lose a single finger!!!! WOO!</blockquote>

[QUOTE="yacob.naif, post: 1991342, member: 565696"] Hey gang, spent the night assembling a 10cf birch box for my L7's, but i have a question/problem i need help with in preparation for tomorrow. I mitred the corners of my box, so the 90 degree angle clamps i was intending to use for assmembling the box were useless, so i had to resort to 16 odd c-clamps on the tops and bottoms of each corner, clamping 2x2's. It didn't occur to me until much too late that those 2x2's may incidently become a fixture in my box [IMG]//content.invisioncic.com/y282845/emoticons/crap.gif.7f4dd41e3e9b23fbd170a1ee6f65cecc.gif[/IMG] hahaha, good thinking, i know. I was wondering if there'd be a way for me to chisel the 2x2's out of the corners? I'd leave them be, but they're not flush with the box, i don't think i'll be able to get the top and bottom of the box on with the 2x2's there. I don't know if it's possible or not, i just don't have much experience (any) with gorilla glue. Is there any glimmor of hope in my future? Or am i gonna be spending a few hours DRILLING 2x2's out of my beautiful baby [IMG]//content.invisioncic.com/y282845/emoticons/crying.gif.ec0ebefe590df0251476573bc49e46d8.gif[/IMG] so frustrating after 9 hours of work.... i've never even mitred before, and i didn't lose a single finger!!!! WOO! [/QUOTE]

Verification