Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Enclosure Design & Construction
question about glassing inside of box
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="orangecounty1" data-source="post: 4412527" data-attributes="member: 578335"><p>when you glass the inside of a box (not just resin, im putting mat down as well)</p><p></p><p>do you just lay the mat, then resin over it and use like a roller or something so it goes down flat with no bubbles, etc? id assume that would be easier to put glass on a flat piece of wood, rather than a brush.</p><p></p><p>also, for the roof/sides, obviously the mat isnt just going to stick until u put the resin, so should i like spray adhesive the mat to the sides and top, then roll resin over that? or resin the wood, then while its still wet, stick the mat, then roll resin over that? would waste alot of resin, but i dont know, ive never done this.</p><p></p><p>any pointers?</p></blockquote><p></p>
[QUOTE="orangecounty1, post: 4412527, member: 578335"] when you glass the inside of a box (not just resin, im putting mat down as well) do you just lay the mat, then resin over it and use like a roller or something so it goes down flat with no bubbles, etc? id assume that would be easier to put glass on a flat piece of wood, rather than a brush. also, for the roof/sides, obviously the mat isnt just going to stick until u put the resin, so should i like spray adhesive the mat to the sides and top, then roll resin over that? or resin the wood, then while its still wet, stick the mat, then roll resin over that? would waste alot of resin, but i dont know, ive never done this. any pointers? [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Enclosure Design & Construction
question about glassing inside of box
Top
Menu
Home
Refresh