Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
General Car Audio
Question about back loaded horn construction
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="ballstothewall" data-source="post: 1323443" data-attributes="member: 559563"><p>Ok, I am building a back loaded horn enclosure for fostex's FE103E driver.</p><p></p><p>The plans are here... <a href="http://www.madisound.com/pdf/fostexcabs/103e_enclrev.pdf" target="_blank">http://www.madisound.com/pdf/fostexcabs/103e_enclrev.pdf</a></p><p></p><p>I was just checking to make sure that it won't matter if I use a round over bit on all internal edges, to give it a smooth laminar airflow. It will be constructed out of 1/2" birch ply on the inside, with a walnut exterior. I will be putting felt in the space behind the driver, and I should put it in the opening of the horn??</p><p></p><p>Thanks for any input, I will be sure to post some pics when I'm done, and maybe some along the construction...</p><p></p><p>-Ryan</p></blockquote><p></p>
[QUOTE="ballstothewall, post: 1323443, member: 559563"] Ok, I am building a back loaded horn enclosure for fostex's FE103E driver. The plans are here... [URL="http://www.madisound.com/pdf/fostexcabs/103e_enclrev.pdf"]http://www.madisound.com/pdf/fostexcabs/103e_enclrev.pdf[/URL] I was just checking to make sure that it won't matter if I use a round over bit on all internal edges, to give it a smooth laminar airflow. It will be constructed out of 1/2" birch ply on the inside, with a walnut exterior. I will be putting felt in the space behind the driver, and I should put it in the opening of the horn?? Thanks for any input, I will be sure to post some pics when I'm done, and maybe some along the construction... -Ryan [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
General Car Audio
Question about back loaded horn construction
Top
Menu
What's new
Forum list
