Reply to thread

Message: <blockquote data-quote="wulff" data-source="post: 1009176" data-attributes="member: 561860">I bought a Q-Logic Model: QLH-1.2512 (this is the inclosure that allows you to use it as a sealed or a ported sub).Anyway, on the inside where the vent enters the middle slot the edge of the wall (where the slot is in the box area) I noticed the edge has sharp edges. I have always known that in a vented box with round ports they should be rounded off on the inside to prevent noise, does this hold true for rectangle ports? I was going to round them off but thought I would check to see if anyone has any information on how the inside rectangle port should be finished off.</blockquote>

Top