Reply to thread

Message

<blockquote data-quote="armored" data-source="post: 560320" data-attributes="member: 557049">Hello,I was reading some posts that you have on a old school punch 200ix amplifier, my question is that I have a old style punch 200IX amplifier, and I am currently running two audiobahn subs, alum12Q and they give me a dual 6 ohm, two make it either capable of 6 ohm operation or a 1.5ohm operation, my question is that do you think that it would be safe to run these subs, they are 1000w rms rating at this ohm load, or will this destroy the amp, I have them ran at 6 ohm operation now but they don&#039;t do the subs any justice.&nbsp; Would like to push the limits, but not too much as to destroy things.&nbsp; However does this amplifier the punch 200IX have a protection circuit inside that will make it not burn out, but kick off, or was that protection not built in back then.&nbsp; I paid $572 in 1994 for the amplifier.&nbsp; However I am sure you know the power capability of this better than I do.&nbsp; Any input that you have would be greatly appreciated.&quot;Re: Help With Wiring 2 10&#039;s--------------------------------------------------------------------------------Wow. Such hostility...gotta love it.An 8ohm load will only give each sub 50w. a 2ohm load will give each sub 200w. To play it safe give each sub their own channel and they will get 100w each.The only reason I said to bridge the amp and give it a 2ohm load in the first place is because it MIGHT be able to take it. I had 2 old school Punch 200ix&#039;s and had them bridged down to 1.33ohms putting out 700w each and they took it all day. Again, if you do this it may or may not work. If you try it keep the gain all the way down and monitor the amp for sign of over heating. When I did it I never turned the gains above 1/4.&quot;</blockquote>

[QUOTE="armored, post: 560320, member: 557049"] Hello, I was reading some posts that you have on a old school punch 200ix amplifier, my question is that I have a old style punch 200IX amplifier, and I am currently running two audiobahn subs, alum12Q and they give me a dual 6 ohm, two make it either capable of 6 ohm operation or a 1.5ohm operation, my question is that do you think that it would be safe to run these subs, they are 1000w rms rating at this ohm load, or will this destroy the amp, I have them ran at 6 ohm operation now but they don't do the subs any justice. Would like to push the limits, but not too much as to destroy things. However does this amplifier the punch 200IX have a protection circuit inside that will make it not burn out, but kick off, or was that protection not built in back then. I paid $572 in 1994 for the amplifier. However I am sure you know the power capability of this better than I do. Any input that you have would be greatly appreciated. "Re: Help With Wiring 2 10's -------------------------------------------------------------------------------- Wow. Such hostility...gotta love it. An 8ohm load will only give each sub 50w. a 2ohm load will give each sub 200w. To play it safe give each sub their own channel and they will get 100w each. The only reason I said to bridge the amp and give it a 2ohm load in the first place is because it MIGHT be able to take it. I had 2 old school Punch 200ix's and had them bridged down to 1.33ohms putting out 700w each and they took it all day. Again, if you do this it may or may not work. If you try it keep the gain all the way down and monitor the amp for sign of over heating. When I did it I never turned the gains above 1/4." [/QUOTE]

Verification