Reply to thread

Message: <blockquote data-quote="amr952" data-source="post: 1217923" data-attributes="member: 562383"><p>Having it wired at 2 ohms is not a problem for this amp, it is 2 ohm stable (As long as you are sure it is wired right)  Is the amp hot when it goes into protection mode? Also upgrading your ground was a good idea to try, you may also want to try and move your ground, make sure you sand it down real good so it is a nice clean surface then mount it real tight. Also check again all the speaker wiring going to the subs. Check and make sure that it is wired for 2 ohms also. You can use a DMM if you like (It will probably be between 1.7 and 2.2 ohms, if not then you have it wired wrong or one of your subs may be bad.</p></blockquote><p></p>

Top