Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
Amplifiers
Protect Pulsing, Help Please
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Xero.Limit" data-source="post: 6128451" data-attributes="member: 585283"><p>I have a Memphis 16-MCD1000 Amp hooked up to one 12" Memphis M3 it's a dual voice coil and I have a Memphis Line Driver 16-VBF1.</p><p></p><p>With all that said everything was just working fine then I notice my subs cut out I pulled over to see what was going on and I find my Amp going in and out of protect everytime the bass hits and makes a clicking sound. I've searched the forums for a bit and have tried everything that was said to check. First I removed the Line Driver to eliminate that, the problem still occurred. I checked my power wire by the battery to make sure it was secure and not touching anything &amp; also checked my ground. I live in Florida and it does get very hot during the summer and my amp was also hot so I pulled it inside so it can cool. I didn't notice anything wrong with the amp but I haven't opened it because I don't want to void the warranty if there even is still one.</p><p></p><p>Any advice would be much appreciated thanks in advance.</p></blockquote><p></p>
[QUOTE="Xero.Limit, post: 6128451, member: 585283"] I have a Memphis 16-MCD1000 Amp hooked up to one 12" Memphis M3 it's a dual voice coil and I have a Memphis Line Driver 16-VBF1. With all that said everything was just working fine then I notice my subs cut out I pulled over to see what was going on and I find my Amp going in and out of protect everytime the bass hits and makes a clicking sound. I've searched the forums for a bit and have tried everything that was said to check. First I removed the Line Driver to eliminate that, the problem still occurred. I checked my power wire by the battery to make sure it was secure and not touching anything & also checked my ground. I live in Florida and it does get very hot during the summer and my amp was also hot so I pulled it inside so it can cool. I didn't notice anything wrong with the amp but I haven't opened it because I don't want to void the warranty if there even is still one. Any advice would be much appreciated thanks in advance. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Amplifiers
Protect Pulsing, Help Please
Top
Menu
What's new
Forum list