Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
Problem - Trying to install sub
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="ZXJ" data-source="post: 1787160" data-attributes="member: 568232"><p>I am going to ground it solidly to the frame right now, I had it on a screw which I thought was attached to the frame but I am not sure. I just took this exact system/setup out of my friends car and it worked, so I am not completely sure on the impedence question.</p><p></p><p>Also, when I was uninstalling the amp wires from my friends deck, the back speakers wires were cut from the main harness and hooked up with speaker wires running through with the signal wires for the amp. Is there a reason why this was done, why the main harness wires werent just kept connected?</p><p></p><p>Thanks again.</p></blockquote><p></p>
[QUOTE="ZXJ, post: 1787160, member: 568232"] I am going to ground it solidly to the frame right now, I had it on a screw which I thought was attached to the frame but I am not sure. I just took this exact system/setup out of my friends car and it worked, so I am not completely sure on the impedence question. Also, when I was uninstalling the amp wires from my friends deck, the back speakers wires were cut from the main harness and hooked up with speaker wires running through with the signal wires for the amp. Is there a reason why this was done, why the main harness wires werent just kept connected? Thanks again. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
Problem - Trying to install sub
Top
Menu
What's new
Forum list
