Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
Problem daisy chaining amps! Help
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="kr15" data-source="post: 6821197" data-attributes="member: 620194"><p>Ok, so i reran all the wiring. The alpine as well as the brutus worked fine when wired by themselves. However, when wired together, they acted funny again. There was that dreaded whining noise coming from my 6x9s. It acted in accordance with acceleration/deceleration. Also, even on full gain, the Alpine is no where near strong enough for my needs. I dont know if it just isnt strong enough to begin with, or if daisy chaining is affecting its ability. Nontheless, it worked perfectly fine when wired by itself. As to the Brutus, increased the gain slightly and that corrected that issue......So, Im back to needing a new deck as my setup just doesnt seem to want to be daisychained...I also will be getting a stronger 4ch...40rms on mids/highs isnt going to cut it against 1200rms to a 15</p></blockquote><p></p>
[QUOTE="kr15, post: 6821197, member: 620194"] Ok, so i reran all the wiring. The alpine as well as the brutus worked fine when wired by themselves. However, when wired together, they acted funny again. There was that dreaded whining noise coming from my 6x9s. It acted in accordance with acceleration/deceleration. Also, even on full gain, the Alpine is no where near strong enough for my needs. I dont know if it just isnt strong enough to begin with, or if daisy chaining is affecting its ability. Nontheless, it worked perfectly fine when wired by itself. As to the Brutus, increased the gain slightly and that corrected that issue......So, Im back to needing a new deck as my setup just doesnt seem to want to be daisychained...I also will be getting a stronger 4ch...40rms on mids/highs isnt going to cut it against 1200rms to a 15 [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
Problem daisy chaining amps! Help
Top
Menu
Home
Refresh