Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
Amplifiers
Power usage question
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="dB-r" data-source="post: 6224360" data-attributes="member: 574699"><p>Wiring at 4 ohm rather than 2 ohm should theoretically use 1/2 the current at the same given voltage. However, if the strain is way less on your electrical (not as much voltage dipping) to the point that your able to maintain a higher voltage going into the amp you would use less than 50% of the power. Which will likely be the case in your Yaris.</p><p></p><p>BUT, I would take the power ratings on that amp with a grain of salt... probably gonna end up being like half of what it's rated for (even half the RMS) and depending on your sub enclosure if you are wiring at 4 ohms your impedance rise is gonna be to like 9 ohms or something playing music most of the time so you won't be seeing whole lot of current draw. Too many variables here, but yes, unless your Yaris has less than a 100 amp alternator you will be okay with that setup at 4 ohms with that amp. I would opt for a good battery though. If it wil fit under the tiny hood. If not put one near the amp, a sealed non-spillable AGM type battery like you would find in a computer battery backup system.</p></blockquote><p></p>
[QUOTE="dB-r, post: 6224360, member: 574699"] Wiring at 4 ohm rather than 2 ohm should theoretically use 1/2 the current at the same given voltage. However, if the strain is way less on your electrical (not as much voltage dipping) to the point that your able to maintain a higher voltage going into the amp you would use less than 50% of the power. Which will likely be the case in your Yaris. BUT, I would take the power ratings on that amp with a grain of salt... probably gonna end up being like half of what it's rated for (even half the RMS) and depending on your sub enclosure if you are wiring at 4 ohms your impedance rise is gonna be to like 9 ohms or something playing music most of the time so you won't be seeing whole lot of current draw. Too many variables here, but yes, unless your Yaris has less than a 100 amp alternator you will be okay with that setup at 4 ohms with that amp. I would opt for a good battery though. If it wil fit under the tiny hood. If not put one near the amp, a sealed non-spillable AGM type battery like you would find in a computer battery backup system. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Amplifiers
Power usage question
Top
Menu
What's new
Forum list