Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
Power Output Calculation
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="AlterEgo99" data-source="post: 5935414" data-attributes="member: 610253"><p>I thought it may be better to create a new thread here for this subject.</p><p></p><p>Here's my question:</p><p></p><p>I have an Alpine PDX 1.600 which is a mono amp rated at 600W X 1 into 4 ohms and 600W X 1 into 2 ohms.</p><p></p><p>My question is if I have 2 (two) 10" subs rated at 300W max each @ 4 ohms and I wire these 2 subs in parallel resulting in a 2 ohm load, what is the max power (wattage) going to EACH sub from the amp? My understanding is that the 600W max output from the amp would be halved, or 300W max into each sub at 2 ohms. Is this right or wrong? Calculations would be helpful! Thanks!</p></blockquote><p></p>
[QUOTE="AlterEgo99, post: 5935414, member: 610253"] I thought it may be better to create a new thread here for this subject. Here's my question: I have an Alpine PDX 1.600 which is a mono amp rated at 600W X 1 into 4 ohms and 600W X 1 into 2 ohms. My question is if I have 2 (two) 10" subs rated at 300W max each @ 4 ohms and I wire these 2 subs in parallel resulting in a 2 ohm load, what is the max power (wattage) going to EACH sub from the amp? My understanding is that the 600W max output from the amp would be halved, or 300W max into each sub at 2 ohms. Is this right or wrong? Calculations would be helpful! Thanks! [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
Power Output Calculation
Top
Menu
What's new
Forum list
