Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
Subwoofers
Ported Enclosure Unloading?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="n2audio" data-source="post: 5991512" data-attributes="member: 540940"><p>I couldn't find t/s data on the 2501's, but the 2502's have a very low vas, at ~2.0cf that sub is probably starting to exhibit free-air behavior.</p><p></p><p>all amp power supplies have some degree of regulation. I would expect the cheap lanzar's are on the loose side.</p><p></p><p>I wouldn't think the amp would clip at 1/2 gain with a 1/2volt signal. The manual says 250mV to 5v on input sensitivity. I guess it could be a very non-linear gain adjustment.</p></blockquote><p></p>
[QUOTE="n2audio, post: 5991512, member: 540940"] I couldn't find t/s data on the 2501's, but the 2502's have a very low vas, at ~2.0cf that sub is probably starting to exhibit free-air behavior. all amp power supplies have some degree of regulation. I would expect the cheap lanzar's are on the loose side. I wouldn't think the amp would clip at 1/2 gain with a 1/2volt signal. The manual says 250mV to 5v on input sensitivity. I guess it could be a very non-linear gain adjustment. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Subwoofers
Ported Enclosure Unloading?
Top
Menu
What's new
Forum list