Reply to thread

Message

<blockquote data-quote="Btnhtillidie" data-source="post: 2323141" data-attributes="member: 570620">OK I designed the box with a cad program and another program cant remember the name but it was highly recommended. Anyways that was a while back, for the life of me I can not find the paperwork I printed out for it. And since then my hard drive crashed and I lost everything. The box is going to hold an 06 XXX. Its built to 2.2 cu ft and it will be 35 Hz&nbsp; If I remember right it was going to be a slot port, but I think I ran into some problems and was going to go with aero ports.here is the thread on the box...<a href="http:////forum/showthread.php?t=185272" target="_blank">http://www.caraudio.com/forum/showthread.php?t=185272</a>As you can see the box is not square, which makes it&nbsp; a little diffcult. It tapers in.I am about ready to get started on the port and am stumped! Any suggestions?Thanks!</blockquote>

[QUOTE="Btnhtillidie, post: 2323141, member: 570620"] OK I designed the box with a cad program and another program cant remember the name but it was highly recommended. Anyways that was a while back, for the life of me I can not find the paperwork I printed out for it. And since then my hard drive crashed and I lost everything. The box is going to hold an 06 XXX. Its built to 2.2 cu ft and it will be 35 Hz If I remember right it was going to be a slot port, but I think I ran into some problems and was going to go with aero ports. here is the thread on the box... [URL="http:////forum/showthread.php?t=185272"]http://www.caraudio.com/forum/showthread.php?t=185272[/URL] As you can see the box is not square, which makes it a little diffcult. It tapers in. I am about ready to get started on the port and am stumped! Any suggestions? Thanks! [/QUOTE]

Verification