Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Enclosure Design & Construction
port fitting difficulty, help please!
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="mestapho" data-source="post: 8656351" data-attributes="member: 675317"><p>So I am designing a 38 x 13 x 21.75 box (external including double front baffle) for 2 SA12 dual 4's</p><p></p><p>net after subs and port is 3.8 cubes tuned to 33.5 (sundown says 35 hz, forums I'm seeing 32 so split the difference) </p><p></p><p>4 x 11.5 x 21 center port. </p><p></p><p>1200 watts from Pioneer 9601.</p><p></p><p>Here's the issue, If I stop the ports to make turns to the sides of the box, half the port width, 2" from the rear wall, the center measurement over 21 inches (22.75") just with the width of the port wall.</p><p></p><p>Is it fine how it is? Should I change it, if so what/how? </p><p></p><p>Any advice is much appreciated.</p><p></p><p>[ATTACH]1130[/ATTACH]</p></blockquote><p></p>
[QUOTE="mestapho, post: 8656351, member: 675317"] So I am designing a 38 x 13 x 21.75 box (external including double front baffle) for 2 SA12 dual 4's net after subs and port is 3.8 cubes tuned to 33.5 (sundown says 35 hz, forums I'm seeing 32 so split the difference) 4 x 11.5 x 21 center port. 1200 watts from Pioneer 9601. Here's the issue, If I stop the ports to make turns to the sides of the box, half the port width, 2" from the rear wall, the center measurement over 21 inches (22.75") just with the width of the port wall. Is it fine how it is? Should I change it, if so what/how? Any advice is much appreciated. [ATTACH]1130._xfImport[/ATTACH] [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Enclosure Design & Construction
port fitting difficulty, help please!
Top
Menu
Home
Refresh