Reply to thread

Message

<blockquote data-quote="des343" data-source="post: 7716659" data-attributes="member: 630654">So basically I am moving so I unhooked the sounds for the space to move. In a hurry to get some sounds back I hook it up late at night when I got out of 2workIn a rush and not paying close enuff attention I put my ground in where my power goes and my power in my ground terminol.I flipped my 250 amvp breaker on thinking im done and suddenly my lights in my car flickered and I instantly flipped the breaker back off since it didn&#039;t automatically...now the amp will not power on for any reason that I have fou d there is no strong burn smell there at first was a very very very faint smell I thought on the end by th terminolsI took the amp apart as it is right mow and I see NOTHING wrong with any transitors resistors capacitors wires nothing....Only issue I just noticed was my rcas need to b soldered on idk when but it came lose and even partially off all together but this im guessing may habe been this way a while?Also there is no way that would cause me not to receive power at all would it? Just maybe no signal or possibly protect mode I get nothi g at all. I&#039;ve made this same stupid mistake a few times im the past but never damaging the amp maybe blowing the fuse at worst or it goes into protectAny ideas what I did to it //content.invisioncic.com/y282845/emoticons/frown.gif.a3531fa0534503350665a1e957861287.gif</blockquote>

[QUOTE="des343, post: 7716659, member: 630654"] So basically I am moving so I unhooked the sounds for the space to move. In a hurry to get some sounds back I hook it up late at night when I got out of 2work In a rush and not paying close enuff attention I put my ground in where my power goes and my power in my ground terminol. I flipped my 250 amvp breaker on thinking im done and suddenly my lights in my car flickered and I instantly flipped the breaker back off since it didn't automatically...now the amp will not power on for any reason that I have fou d there is no strong burn smell there at first was a very very very faint smell I thought on the end by th terminols I took the amp apart as it is right mow and I see NOTHING wrong with any transitors resistors capacitors wires nothing.... Only issue I just noticed was my rcas need to b soldered on idk when but it came lose and even partially off all together but this im guessing may habe been this way a while? Also there is no way that would cause me not to receive power at all would it? Just maybe no signal or possibly protect mode I get nothi g at all. I've made this same stupid mistake a few times im the past but never damaging the amp maybe blowing the fuse at worst or it goes into protect Any ideas what I did to it [IMG]//content.invisioncic.com/y282845/emoticons/frown.gif.a3531fa0534503350665a1e957861287.gif[/IMG] [/QUOTE]

Verification