Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Enclosure Design & Construction
Plans for an SPL Box, optimum tuning frequency? Trying to pass 150dB
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="RSDXzec" data-source="post: 8246476" data-attributes="member: 638347"><p>hmm so i was fairly close to begin with on port area and almost on volume, so would you say 14 cubes after port displacement?</p><p></p><p>and I think rather than reduce the height i'll reduce the length of the box so I have more room for the box to vent.</p><p></p><p>I'm also planning on having the port driver side, since the termlab goes on passenger side.</p><p></p><p>edit: I'm thinking based on all the recommendations so far I'm going to go with 14 cubes after displacements tuned to 44hz, kinda fits a few musical requirements I have as well.</p><p></p><p>Going on the larger side because I'll be running low power, and I did want a higher tune so 44 seems to fit.</p><p></p><p>another question I have is should I mount all four subwoofers as close as possible to the rear of the vehicle? or should I place 2 near the rear and 2 near the front? remember all subs will be facing up with the port back on driver side.</p></blockquote><p></p>
[QUOTE="RSDXzec, post: 8246476, member: 638347"] hmm so i was fairly close to begin with on port area and almost on volume, so would you say 14 cubes after port displacement? and I think rather than reduce the height i'll reduce the length of the box so I have more room for the box to vent. I'm also planning on having the port driver side, since the termlab goes on passenger side. edit: I'm thinking based on all the recommendations so far I'm going to go with 14 cubes after displacements tuned to 44hz, kinda fits a few musical requirements I have as well. Going on the larger side because I'll be running low power, and I did want a higher tune so 44 seems to fit. another question I have is should I mount all four subwoofers as close as possible to the rear of the vehicle? or should I place 2 near the rear and 2 near the front? remember all subs will be facing up with the port back on driver side. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Enclosure Design & Construction
Plans for an SPL Box, optimum tuning frequency? Trying to pass 150dB
Top
Menu
Home
Refresh