Reply to thread

Message

<blockquote data-quote="PeanutEOD" data-source="post: 8920816" data-attributes="member: 694462">Ok, I&#039;ve been collecting the pieces I need for my build. Kinda planning it out before I install everything and get toward the end and realize I&#039;m missing one piece. So far, I have:CT Sounds 6X9&quot; MESO Coax in the front doors with mounting rings foam baffle cups and harness adapter.CT Sounds 6.5&quot; MESO Coax in the rear doors with mounting rings foam baffle cups and harness adapter.CT Sounds 12&quot; Sub in a box.CT Sounds CT-1500.5D 5 channel amplifier.Audio Control LC8i Line Output Converter.KnuKonceptz wire for amp power, ground, RCAs, speaker wire to the sub box, and remote turn on wire.Both AutoHarnessHouse wiring harnesses for the factory Harman Kardon Amp.9 Conductor 16 AWG wire for the signal transfer.My plan is to cut the AHH harness speaker wires coming out of the HK amp and send that signal to the LC8i. RCAs will connect the LC8i to the CT Sounds amp. Then the amplified signal will be sent to the speakers through the other side of the AHH harness plugged into the factory harness. Anyone have experience with this setup? Not necessarily the exact same setup, but amplifying the speakers in the 22 and up WRX, not just adding a sub.[ATTACH=full]70749[/ATTACH]</blockquote>

[QUOTE="PeanutEOD, post: 8920816, member: 694462"] Ok, I've been collecting the pieces I need for my build. Kinda planning it out before I install everything and get toward the end and realize I'm missing one piece. So far, I have: CT Sounds 6X9" MESO Coax in the front doors with mounting rings foam baffle cups and harness adapter. CT Sounds 6.5" MESO Coax in the rear doors with mounting rings foam baffle cups and harness adapter. CT Sounds 12" Sub in a box. CT Sounds CT-1500.5D 5 channel amplifier. Audio Control LC8i Line Output Converter. KnuKonceptz wire for amp power, ground, RCAs, speaker wire to the sub box, and remote turn on wire. Both AutoHarnessHouse wiring harnesses for the factory Harman Kardon Amp. 9 Conductor 16 AWG wire for the signal transfer. My plan is to cut the AHH harness speaker wires coming out of the HK amp and send that signal to the LC8i. RCAs will connect the LC8i to the CT Sounds amp. Then the amplified signal will be sent to the speakers through the other side of the AHH harness plugged into the factory harness. Anyone have experience with this setup? Not necessarily the exact same setup, but amplifying the speakers in the 22 and up WRX, not just adding a sub. [ATTACH type="full"]70749[/ATTACH] [/QUOTE]

Verification