Reply to thread

Message

<blockquote data-quote="keep_hope_alive" data-source="post: 7604682" data-attributes="member: 576029">Are you using this LOC on the speaker outputs of the Kenwood DPX308U in your sig or is this going into a different system?&nbsp;&nbsp; If you have the Kenwood, don&#039;t mess with the LOC and just run RCA&#039;s from the HU.For factory HU connections - you need to connect the front left and front right speaker wires to the LOC wires.&nbsp; Right is Gray and Left is White.&nbsp; you&#039;ll make four separate connections, Pos and Neg on each Left and Right.follow the manual wiring diagram for stereo output.&nbsp; set Input as Wired and set Output as RCA and use the associated harnesses.<a href="http://www.pac-audio.com/PACProductData/SOEM-T/1_Instructions/soem-t_instructions_091709.pdf" target="_blank">http://www.pac-audio.com/PACProductData/SOEM-T/1_Instructions/soem-t_instructions_091709.pdf</a>you describe mono wiring which will not give you stereo separation.&nbsp; you want stereo separation for the front speakers.</blockquote>

[QUOTE="keep_hope_alive, post: 7604682, member: 576029"] Are you using this LOC on the speaker outputs of the Kenwood DPX308U in your sig or is this going into a different system? If you have the Kenwood, don't mess with the LOC and just run RCA's from the HU. For factory HU connections - you need to connect the front left and front right speaker wires to the LOC wires. Right is Gray and Left is White. you'll make four separate connections, Pos and Neg on each Left and Right. follow the manual wiring diagram for stereo output. set Input as Wired and set Output as RCA and use the associated harnesses. [URL="http://www.pac-audio.com/PACProductData/SOEM-T/1_Instructions/soem-t_instructions_091709.pdf"]http://www.pac-audio.com/PACProductData/SOEM-T/1_Instructions/soem-t_instructions_091709.pdf[/URL] you describe mono wiring which will not give you stereo separation. you want stereo separation for the front speakers. [/QUOTE]

Verification