Reply to thread

Message

<blockquote data-quote="luv2ski" data-source="post: 5503283" data-attributes="member: 606523">--------------------------------------------------------------------------------My Winter project was to upgrade my sound system in my boat and now I have most of the pieces and understand that this is a budget system, but it is still a big upgrade from what was peviously installed.&nbsp;&nbsp; The problem is I&nbsp; may have got some bad advice along the way. Here is what I have.Sony CDX L410X DeckJensen 4 CH. 1304 Amp (120 RMS per ch.)2 Infinity 1252 12 inch subs in 1.25 cubic foot cabinets4 Sony explode 6x9 in cabinets 70 RMS rated each(tried in and not in and liked the sound in the cabinets better)2 Pyle component speakers 6.5 inch plus tweeter 120 RMS rated each2 pioneer 4 inch speakersI only have 2 preamps out of the deck so I had to split to do all 4 channels. I have the subs on channels 3 and 4 and then I have 2 6x9s on channel 1 and 2 6x9s on channel 2. Then I have the remaining speakers hooked to the deck 17 RMS per channel.Does this sound like the best way to set this up and the advice I got about being ok to run 2 speakers off a channel is that correct.? It sounds nice for my taste in the garage, but I have not really turned it up yet and with all the experience in Audio on this forum I value your opinions.Thanks and pray for an early Spring</blockquote>

[QUOTE="luv2ski, post: 5503283, member: 606523"] -------------------------------------------------------------------------------- My Winter project was to upgrade my sound system in my boat and now I have most of the pieces and understand that this is a budget system, but it is still a big upgrade from what was peviously installed. The problem is I may have got some bad advice along the way. Here is what I have. Sony CDX L410X Deck Jensen 4 CH. 1304 Amp (120 RMS per ch.) 2 Infinity 1252 12 inch subs in 1.25 cubic foot cabinets 4 Sony explode 6x9 in cabinets 70 RMS rated each(tried in and not in and liked the sound in the cabinets better) 2 Pyle component speakers 6.5 inch plus tweeter 120 RMS rated each 2 pioneer 4 inch speakers I only have 2 preamps out of the deck so I had to split to do all 4 channels. I have the subs on channels 3 and 4 and then I have 2 6x9s on channel 1 and 2 6x9s on channel 2. Then I have the remaining speakers hooked to the deck 17 RMS per channel. Does this sound like the best way to set this up and the advice I got about being ok to run 2 speakers off a channel is that correct.? It sounds nice for my taste in the garage, but I have not really turned it up yet and with all the experience in Audio on this forum I value your opinions. Thanks and pray for an early Spring [/QUOTE]

Verification