Reply to thread

Message: <blockquote data-quote="ARK_SWAMP_RIDER" data-source="post: 6723876" data-attributes="member: 585878"><p>I've got a 03 4runner with a factory JBL amplified stereo system. I am adding an aftermarket amp/sub combo. The sub is going in place of the OEM one. Since I'm running the OEM head unit, I'll need to use the speaker level inputs on the amp. Where would be the best place to tap in? The OEM sub a DVC, so I've got two sets of wires leaving the amp. I'd like to tap in here, but I'm not sure about using the already amplified signal. My second option is tapping into the wiring as it enters the amp, but this will be much harder because I'll need to find the right wiring. Any advice? Thanks!</p></blockquote><p></p>

Top