Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
ok, more assistance
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="mr.gaf" data-source="post: 7907178" data-attributes="member: 644848"><p>I messed with the speaker wiring a little on my setup. The amp is a AP10001D:</p><p></p><p>1000W Monoblock Power AmplifierRemote Bass Control Included1 Ohm load stableBass Boost 0-12dBOverheat protectionVariable subsonic filterDistortions:</p><p></p><p>The subs are CVR10s (2) dvc 4 ohm 400-800 watts. If I hook them up at 1 ohm, the amp goes into protection mode, at 2 ohms it does fine, but that's only 700 watts so 350 to each and thus not enough. Thoughts?</p></blockquote><p></p>
[QUOTE="mr.gaf, post: 7907178, member: 644848"] I messed with the speaker wiring a little on my setup. The amp is a AP10001D: 1000W Monoblock Power AmplifierRemote Bass Control Included1 Ohm load stableBass Boost 0-12dBOverheat protectionVariable subsonic filterDistortions: The subs are CVR10s (2) dvc 4 ohm 400-800 watts. If I hook them up at 1 ohm, the amp goes into protection mode, at 2 ohms it does fine, but that's only 700 watts so 350 to each and thus not enough. Thoughts? [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
ok, more assistance
Top
Menu
What's new
Forum list
