Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Discussion
Car Audio Build Logs
NSTALN's Froggy Frontier 5.1 surround build
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="NSTALN" data-source="post: 8577624" data-attributes="member: 588169"><p>The distro-block is an older Streetwires model CBM-44 or something like that...pretty sure they don't make them anymore but there are a few similar products on the market. I am going mostly active...the only passive units will be the GB crossovers going to the GB25's (which I'll add later) and the GB10's. The plan is to do active (8) channels from the DSP; front high left, front high right (GB tweets), front low left, front low right (GS690's), center GS42, rears left &amp; right GS62's, and sub.</p><p></p><p>...but I have the GB25's....and they would sound nice in a 3-way (with the GB10 and GS690)...so I figured I would install the crossovers and pre-run extra speaker runs for when/if I add the GB25's. So adding the crossovers and GB25's to the front high left &amp; right would do the trick. The crossovers are beefy as Hell...BIG components.</p></blockquote><p></p>
[QUOTE="NSTALN, post: 8577624, member: 588169"] The distro-block is an older Streetwires model CBM-44 or something like that...pretty sure they don't make them anymore but there are a few similar products on the market. I am going mostly active...the only passive units will be the GB crossovers going to the GB25's (which I'll add later) and the GB10's. The plan is to do active (8) channels from the DSP; front high left, front high right (GB tweets), front low left, front low right (GS690's), center GS42, rears left & right GS62's, and sub. ...but I have the GB25's....and they would sound nice in a 3-way (with the GB10 and GS690)...so I figured I would install the crossovers and pre-run extra speaker runs for when/if I add the GB25's. So adding the crossovers and GB25's to the front high left & right would do the trick. The crossovers are beefy as Hell...BIG components. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Car Audio Build Logs
NSTALN's Froggy Frontier 5.1 surround build
Top
Menu
Home
Refresh