Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
noob power wire question
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Cm_low" data-source="post: 8553097" data-attributes="member: 671764"><p>The tn4 is rated at 2x40 amp fuses and the rockford 50 amp fuse recommended so a total of 140 amp draw. I personally have never worked with knukoncept wire but if it true 4 gauge ofc it should handle that kind of draw. I would fuse off the battery up front then fuse the wire after distribution block to each amp to the respective amplifiers draw. If you have plenty of 4 gauge ofc lying around I personally would run 2 runs of the 4 gauge ofc to the distribution block from the front, which would be equivalent to 0 gauge, then a run of 4 gauge to each amp from distribution block with each amps respective fuse recommendation in line after the distribution block.</p></blockquote><p></p>
[QUOTE="Cm_low, post: 8553097, member: 671764"] The tn4 is rated at 2x40 amp fuses and the rockford 50 amp fuse recommended so a total of 140 amp draw. I personally have never worked with knukoncept wire but if it true 4 gauge ofc it should handle that kind of draw. I would fuse off the battery up front then fuse the wire after distribution block to each amp to the respective amplifiers draw. If you have plenty of 4 gauge ofc lying around I personally would run 2 runs of the 4 gauge ofc to the distribution block from the front, which would be equivalent to 0 gauge, then a run of 4 gauge to each amp from distribution block with each amps respective fuse recommendation in line after the distribution block. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
noob power wire question
Top
Menu
Home
Refresh