Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
Noise!
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="adebeer" data-source="post: 1389140" data-attributes="member: 565284"><p>I just finished my install and I have a really bad hiss in the fronts. I am running the front comps off a bridged jl 300/4. Any time I turn the volume up past 0 I get a really bad hiss through the speaks, even with the engine off. I have the HU grounded to the chassis by the HU and the amp grounded at a seatbelt bolt in the rear. The power and signal wires are run down opposite sides of the truck, but one speaker wire does run over the 0/1ga power wire right behind the firewall, but I crossed them at 90degrees. I think it may be a ground loop and was going to try regrounding the HU at the same spot as the amps on the rear seatbelt. Does this sound correct?</p></blockquote><p></p>
[QUOTE="adebeer, post: 1389140, member: 565284"] I just finished my install and I have a really bad hiss in the fronts. I am running the front comps off a bridged jl 300/4. Any time I turn the volume up past 0 I get a really bad hiss through the speaks, even with the engine off. I have the HU grounded to the chassis by the HU and the amp grounded at a seatbelt bolt in the rear. The power and signal wires are run down opposite sides of the truck, but one speaker wire does run over the 0/1ga power wire right behind the firewall, but I crossed them at 90degrees. I think it may be a ground loop and was going to try regrounding the HU at the same spot as the amps on the rear seatbelt. Does this sound correct? [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
Noise!
Top
Menu
What's new
Forum list