Reply to thread

Message: <blockquote data-quote="tech" data-source="post: 8414726" data-attributes="member: 666969">I was able to successfully jump the amp with the car off and key not in the ignition. This confirms that the issue is with the remote wire. Furthermore, I did some voltage tests at various different points and found the power cable to the amp had the full 12+ volts, power to my LOC had about 5 volts, power on the remote in to my LOC showed 12+volts, power at the remote out of my LOC showed 5 volts, and power at the remote in of my amp showed the same 5 volts that the LOC remote out was reading.Should my LOC be reading 5 volts at the power and remote out? It's reading 12 volts on the remote in.</blockquote>

Top