Reply to thread

Message

<blockquote data-quote="cgraz1187" data-source="post: 3312795" data-attributes="member: 569748">I am trying to install a jensen 5610 headunit, along with 6.5 coax. in the front and power acoustik 6.5 midbass drivers in the back, powered by a jensen powerplus 760. Yes, this is a cheap *** system, but I am installing it for a friend in his 1986 toyota pickup as he only had two speakers and a cassete player.This is the problem, I installed the midbass drivers in the bcak and the 6.5 in the front, I used the existeing wiring from the original speakers in the doors, and I ran 14g speaker wire from the wiring harness back to the amplifier, the deck only has 1 set of preouts so I used two y-splitters to hook up the 4 channel. all of the speakers are connected correctly, but I am getting no sound from the headunit. When I turn the key on, I get a crazy sounding signal, that runs through all 4 speakers, and slams the midbass&#039;, but no music, I quickly unplug the chan 1 input and the signal stops, if I replug the rca back in, nothing happens until I turn the key off then on again, and the signal from mars comes back.I tried the hook a single speaker up to one of the headunits speaker wires directly, and I received no sound from that speaker either. This leads be to believe the headunit is bad. I am going to hook up a different hu tommarrow to confirm,but in the meantime does anyone have any suggestions?Thanks</blockquote>

[QUOTE="cgraz1187, post: 3312795, member: 569748"] I am trying to install a jensen 5610 headunit, along with 6.5 coax. in the front and power acoustik 6.5 midbass drivers in the back, powered by a jensen powerplus 760. Yes, this is a cheap *** system, but I am installing it for a friend in his 1986 toyota pickup as he only had two speakers and a cassete player. This is the problem, I installed the midbass drivers in the bcak and the 6.5 in the front, I used the existeing wiring from the original speakers in the doors, and I ran 14g speaker wire from the wiring harness back to the amplifier, the deck only has 1 set of preouts so I used two y-splitters to hook up the 4 channel. all of the speakers are connected correctly, but I am getting no sound from the headunit. When I turn the key on, I get a crazy sounding signal, that runs through all 4 speakers, and slams the midbass', but no music, I quickly unplug the chan 1 input and the signal stops, if I replug the rca back in, nothing happens until I turn the key off then on again, and the signal from mars comes back. I tried the hook a single speaker up to one of the headunits speaker wires directly, and I received no sound from that speaker either. This leads be to believe the headunit is bad. I am going to hook up a different hu tommarrow to confirm, but in the meantime does anyone have any suggestions? Thanks [/QUOTE]

Verification