Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
Newbie Radio and Subwoofer install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="HardofWhoring" data-source="post: 8841446" data-attributes="member: 674149"><p>NO, NO, and NO. </p><p></p><p>The ignition wire on the radio harness goes to your vehicle's ignition. It should connect through the vehicle's harness. </p><p></p><p>The orange illumination wire is so that you can control the brightness of the head unit display, with the adjustable brightness of the gauges. If you have it in your harness, then connect it. If you don't, then don't worry about it. </p><p></p><p>The remote wire / blue with white stripe is a signal wire for the amplifier. It is just a switch, on/off so that the amp turns off when the head unit turns off. </p><p></p><p>as for the amps power cables, It could be wrapped from the factory for shipping. Can you take a picture of that?</p></blockquote><p></p>
[QUOTE="HardofWhoring, post: 8841446, member: 674149"] NO, NO, and NO. The ignition wire on the radio harness goes to your vehicle's ignition. It should connect through the vehicle's harness. The orange illumination wire is so that you can control the brightness of the head unit display, with the adjustable brightness of the gauges. If you have it in your harness, then connect it. If you don't, then don't worry about it. The remote wire / blue with white stripe is a signal wire for the amplifier. It is just a switch, on/off so that the amp turns off when the head unit turns off. as for the amps power cables, It could be wrapped from the factory for shipping. Can you take a picture of that? [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
Newbie Radio and Subwoofer install
Top
Menu
Home
Refresh