Reply to thread

Message

<blockquote data-quote="Austin" data-source="post: 214902" data-attributes="member: 547962"><img src="http://www.cashville.net/systemdraft.jpg" alt="" class="fr-fic fr-dii fr-draggable " style="" />ok, thats what its going to becurrently it is one PPI 2200 and 2 12&quot; w3v2&#039;s and the CDA-7878 HU....now for the parts I dont understandsince I did not install waht I currently have(shop did, before i knew a **** thing abotu car audio) I have a few questions.1. how does the RCA&#039;s go to the amps? Are there enough outputs? Does the sub-out get split to go to both amps? Then is there another output for the 4channel amp for the doors?2.&nbsp; Fuses/Distribution blocks/Wiring?&nbsp; Ok, so I currently have 4 gauge going to my amp, I think i&#039;m going to have to upgrade to 1ga..how do I figure that out? Also, what size inline fuse would I need next to my battery? From my battery i go to the inline fuse..then to a distribution block then to my amps, correct? Does a distribution block have fuses? What gauge wire should I use to my door speakers, i&#039;m thinking 12gauge. I heard to use 12gauge to my doors then 16 to my tweets from the crossovers. Does anyone know where to buy spools of wire that would be good for this?3. Do I have to setup the crossovers myself? Also can you cahnge the amount of power going to different channels on the 4 channel amp?&nbsp; Because the fronts could use more power and the rear a little bit less.4. Is their anything else that I need to know about when wiring/installing this stuff that you dont normally hear about? any suggestions? Thanks</blockquote>

[QUOTE="Austin, post: 214902, member: 547962"] [IMG]http://www.cashville.net/systemdraft.jpg[/IMG] ok, thats what its going to be currently it is one PPI 2200 and 2 12" w3v2's and the CDA-7878 HU.... now for the parts I dont understand since I did not install waht I currently have(shop did, before i knew a **** thing abotu car audio) I have a few questions. 1. how does the RCA's go to the amps? Are there enough outputs? Does the sub-out get split to go to both amps? Then is there another output for the 4channel amp for the doors? 2. Fuses/Distribution blocks/Wiring? Ok, so I currently have 4 gauge going to my amp, I think i'm going to have to upgrade to 1ga..how do I figure that out? Also, what size inline fuse would I need next to my battery? From my battery i go to the inline fuse..then to a distribution block then to my amps, correct? Does a distribution block have fuses? What gauge wire should I use to my door speakers, i'm thinking 12gauge. I heard to use 12gauge to my doors then 16 to my tweets from the crossovers. Does anyone know where to buy spools of wire that would be good for this? 3. Do I have to setup the crossovers myself? Also can you cahnge the amount of power going to different channels on the 4 channel amp? Because the fronts could use more power and the rear a little bit less. 4. Is their anything else that I need to know about when wiring/installing this stuff that you dont normally hear about? any suggestions? Thanks [/QUOTE]

Verification