Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
General Car Audio
New SoundStream amp going into protect
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="low00ranger" data-source="post: 7904693" data-attributes="member: 563341"><p>I just got a new SoundStream Rubicon 1.700 this week along with a pair of new JL 10W3v3s. I got everything wired and connected with the subs wired in series at 2 ohms. The first time I powered up the amp, the speakers popped and the amp went into protect immediately. I turned the car off and made sure all connections were solid, as they were. Turned the car back on and the amp goes into protect again. I verified that:</p><p></p><p>*14.3v power coming into the amp</p><p></p><p>*13.5v coming from remote wire</p><p></p><p>*Amp is seeing a 2.1 ohm load from speakers</p><p></p><p>I turned the car off and disconnected the RCA leads and speaker output wiring. Turn the car back on with just power, remote, and ground leads and it STILL goes into protect. Is this amp defective?</p></blockquote><p></p>
[QUOTE="low00ranger, post: 7904693, member: 563341"] I just got a new SoundStream Rubicon 1.700 this week along with a pair of new JL 10W3v3s. I got everything wired and connected with the subs wired in series at 2 ohms. The first time I powered up the amp, the speakers popped and the amp went into protect immediately. I turned the car off and made sure all connections were solid, as they were. Turned the car back on and the amp goes into protect again. I verified that: *14.3v power coming into the amp *13.5v coming from remote wire *Amp is seeing a 2.1 ohm load from speakers I turned the car off and disconnected the RCA leads and speaker output wiring. Turn the car back on with just power, remote, and ground leads and it STILL goes into protect. Is this amp defective? [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
General Car Audio
New SoundStream amp going into protect
Top
Menu
What's new
Forum list
