Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
New issue :/
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="VWBobby" data-source="post: 8253944" data-attributes="member: 624844"><p>Least expensive but accurate way is with a Nano Oscilloscope <a href="http://www.ebay.com/itm/like/200470598507?lpid=82" target="_blank">Arm DSO Nano Pocket Sized Digital Oscilloscope | eBay</a> ...about $70. An SMD DD1 runs around $100.</p><p></p><p>You could just turn down the gain and it might help. If you are running 4 ohm speakers, 1 per channel, you shouldn't have any problems with it cutting out around 1/4 gain, especially with 2V preamp outs on your HU. Again, it is best to adjust your gain with an oscilloscope or DD1 rather than tuning by ear.</p><p></p><p>Good tip on checking for shorts in your speakers or wiring. Check everything with an ohm meter and visually inspect your wires for tears.</p></blockquote><p></p>
[QUOTE="VWBobby, post: 8253944, member: 624844"] Least expensive but accurate way is with a Nano Oscilloscope [URL="http://www.ebay.com/itm/like/200470598507?lpid=82"]Arm DSO Nano Pocket Sized Digital Oscilloscope | eBay[/URL] ...about $70. An SMD DD1 runs around $100. You could just turn down the gain and it might help. If you are running 4 ohm speakers, 1 per channel, you shouldn't have any problems with it cutting out around 1/4 gain, especially with 2V preamp outs on your HU. Again, it is best to adjust your gain with an oscilloscope or DD1 rather than tuning by ear. Good tip on checking for shorts in your speakers or wiring. Check everything with an ohm meter and visually inspect your wires for tears. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
New issue :/
Top
Menu
What's new
Forum list
