Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
New Hertz Build, but 9 wire question
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Ethosb" data-source="post: 7786315" data-attributes="member: 642471"><p>Keep_Hope_Alive:</p><p></p><p>It does not have the factory amp. Only runs off the HU. I figured if I used the LOC to tap into, then I would avoid tapping the factory harness. I don't like the idea of tapping into the harness. I plan on running new speaker wire from the amp to the speakers/crossovers and just sealing off the factory ones for later use if I remove the speakers.</p><p></p><p>As for speaker brackets I have a sheet of stainless steel that I will manufacture brackets from and then will put a rubberized coating on the brackets prior to install to reduce vibrations.</p></blockquote><p></p>
[QUOTE="Ethosb, post: 7786315, member: 642471"] Keep_Hope_Alive: It does not have the factory amp. Only runs off the HU. I figured if I used the LOC to tap into, then I would avoid tapping the factory harness. I don't like the idea of tapping into the harness. I plan on running new speaker wire from the amp to the speakers/crossovers and just sealing off the factory ones for later use if I remove the speakers. As for speaker brackets I have a sheet of stainless steel that I will manufacture brackets from and then will put a rubberized coating on the brackets prior to install to reduce vibrations. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
New Hertz Build, but 9 wire question
Top
Menu
Home
Refresh