Reply to thread

Message

<blockquote data-quote="dkguitarist" data-source="post: 1571917" data-attributes="member: 557124">i&#039;m looking to go active here. 2-way comp set needed. prefer diy route. 6.5&quot; needed.&nbsp; and i do know about diymobileaudio.com but i want YOUR opinions and i will look into them as wellamps i have are two diamonds:d3 400.2Type: Full RangeChannels: 2RMS @ 4 Ohm: 100 x 2RMS Mono: 400 x 1 @ 4 OhmTHD: 0.05%Crossovers: Low Pass, High Passd5 300.2CHANNELS: 2o AMP OUTPUT: @ 11V - 14.5Vo RMS @ 4 Ohms = 75 x 2o RMS @ 2 Ohms = 150 x 2o RMS @ 4 Ohms = 300 x 1 Bridged* Fully regulated power supply* Variable Electronic Crossovers* Nickel Plated Solid Brass 4-gauge Power Connectors* Nickel Plated Solid Brass 10-gauge Speaker Connectors* 2 Oz Silver Plated Copper Circuit Board* THD: .03%* F/R: 10Hz -50Khz* S/N: 100dB* Channel Separation: 80dB* Amplifer Size: 12.5&quot; x 2.75&quot; x 12&quot;* FUSE RATING: 60 AMP MAX* MADE IN THE USAthis is what i have to work with. also i listen to alot of punk/emo/ska/hardcore/metal and some rap.as for tweeters i&#039;d probly prefer soft/silk tweeters.</blockquote>

[QUOTE="dkguitarist, post: 1571917, member: 557124"] i'm looking to go active here. 2-way comp set needed. prefer diy route. 6.5" needed. and i do know about diymobileaudio.com but i want YOUR opinions and i will look into them as well amps i have are two diamonds: d3 400.2 Type: Full Range Channels: 2 RMS @ 4 Ohm: 100 x 2 RMS Mono: 400 x 1 @ 4 Ohm THD: 0.05% Crossovers: Low Pass, High Pass d5 300.2 CHANNELS: 2 o AMP OUTPUT: @ 11V - 14.5V o RMS @ 4 Ohms = 75 x 2 o RMS @ 2 Ohms = 150 x 2 o RMS @ 4 Ohms = 300 x 1 Bridged * Fully regulated power supply * Variable Electronic Crossovers * Nickel Plated Solid Brass 4-gauge Power Connectors * Nickel Plated Solid Brass 10-gauge Speaker Connectors * 2 Oz Silver Plated Copper Circuit Board * THD: .03% * F/R: 10Hz -50Khz * S/N: 100dB * Channel Separation: 80dB * Amplifer Size: 12.5" x 2.75" x 12" * FUSE RATING: 60 AMP MAX * MADE IN THE USA this is what i have to work with. also i listen to alot of punk/emo/ska/hardcore/metal and some rap. as for tweeters i'd probly prefer soft/silk tweeters. [/QUOTE]

Verification