Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Equipment
Amplifiers
Need some help.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="k.bean" data-source="post: 2531965" data-attributes="member: 572455"><p>I have a mono amp rated at 657 watts @ 2ohms with two SVC subs wired to it. The amp has two sets of +/- speaker connections and is internally wired in parellel. I want to send 300 watts to each of my subs. When I set my gains I used a DMM and put the probes into the left set of speaker connections. I found the desired voltage to get 300watts to be 24.49V so I set the gain until it reached this point. After I reconnected the subs and fired them up, they didn't seem very loud. I'm wondering if my gain setting is right, because it ended up at being set far below the half way mark. I don't see how this could be right since it should be putting out 600 watts, almost all of its rated power.</p><p></p><p>Its pretty hard for me to explain this but let me know if you have any knowledge with this kind of amp set up. Thanks</p></blockquote><p></p>
[QUOTE="k.bean, post: 2531965, member: 572455"] I have a mono amp rated at 657 watts @ 2ohms with two SVC subs wired to it. The amp has two sets of +/- speaker connections and is internally wired in parellel. I want to send 300 watts to each of my subs. When I set my gains I used a DMM and put the probes into the left set of speaker connections. I found the desired voltage to get 300watts to be 24.49V so I set the gain until it reached this point. After I reconnected the subs and fired them up, they didn't seem very loud. I'm wondering if my gain setting is right, because it ended up at being set far below the half way mark. I don't see how this could be right since it should be putting out 600 watts, almost all of its rated power. Its pretty hard for me to explain this but let me know if you have any knowledge with this kind of amp set up. Thanks [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Equipment
Amplifiers
Need some help.
Top
Menu
Home
Refresh